The first one is an Asian and Domestic for if you already have 4. The next link takes you to a bundle that has the 4. Genisys Domestic, Asian, 4. Date: June 22, pm. I have the Mac Mentor scan tool it currently has the 3.
Brian, yes the bundle kit linked in one of the previous comments would be what you need to update your scan tool. It is always best to make sure when it comes to software, because there are no returns for software related products. Date: November 8, pm. Date: November 9, am. You may want to contact OTCtools. Date: February 21, am.
We found the datastream but we dont know how to use the scanner to recallibrate. Date: February 21, pm. Mark, most likely a repair manual will be needed. Good Luck. Date: March 23, pm. Seb, that is something that individuals have to decide for themselves. I my opinion for the money, the Genisys EVO is the best value. Date: April 10, pm. I have an older mac mentor with the black power button and a lab scope. I am thinking of purchasing a new unit, seems like a good deal. Unfortunately, I lost my smart card for the scope do you have the card available that will work with the old scope and new unit.
Date: January 14, am. I have an older 3. Mine is in excellent condition. Date: January 14, pm. Ron, You could use the OTC update which is less expensive than a new scan tool. The EVO: on the right side of the tool, you only have one slot. The instructions with the tool are not very clear at this point. You will be prompted for smart cards that you do not have. This is another important point.
Do not press EXIT. If you do, you will be prompted to power off the tool and remove the memory card. You will have to start the installation all over and end up in a loop. You want to press enter. You will get a message that the feature will be loaded onto the tool but not authorized. That is ok. Just click enter again. Starting with the 5. There are two ways you can do this.
Second: I think this is the easiest. Call Customer Service At the first prompt choose option 1 and choose option 1 again at the next prompt. An OTC customer service agent will register your tool for you and give you an authorization code.
You must be logged in to post a comment. Click on each one and click remove or uninstall. The next screen asks if you want to check the internet for updates. Click YES.
It is going to ask you to insert your smart cards. This is where you must pay attention. So, I had to put the memory card back into the USB card reader and run the update software again and go through the process again. I then loaded the memory card back into the Genisys. This time with the seal on the Domestic card facing UP — even though the card was upside down… it loaded properly. One of those things that is simple once you realize, what should be obvious!
Email will NOT be shared. Your Website Not required. Please note: Your comment will not be posted until it's approved. We appreciate and read all on topic, relevant comments. Please don't ask for repair manual info like torque specs, wiring diagrams and specific repair procedures.
0コメント